Why would a cable operated pto differ from an electrically actuated pump? The tri-axle plow truck I run in the winter time has a 6 speed allison automatic in it, just flip the switch and pto activates regardless of whether the truck is stopped/moving/in neutral/in gear etc. Posted 08:10 (#2076273 - in reply to #2075415) Subject: Re: anyone ever put a chelsea pto on a allison automatic? Just remember that if you are going to install a cable operated pto on a auto trans you have to stop the drive gear in the transmission by putting the transmission in gear and then engage pto and then place trans back in nuetral to spin pto. Posted 21:15 (#2075415 - in reply to #2074804) Subject: Re: anyone ever put a chelsea pto on a allison automatic? I got a direct mount pump ordered for it too. Its switched on electrically and can be turned on when ever. Posted 19:32 (#2075160 - in reply to #2075129) Subject: Re: anyone ever put a chelsea pto on a allison automatic?ĭidn't seem to be a problem getting one for a 2500 RDS Allison. They wanted the serial number to get the right one and said it was not that common. Is there a style that pumps all the time and another style you turn off and on? On our automatic the pto is switched on with a electrical switch and can be engaged any time. Getting the right one is likely harder than installing it. Posted 19:18 (#2075129 - in reply to #2075071) Subject: Re: anyone ever put a chelsea pto on a allison automatic? It's not as simple as just adding the gear in the trans either. Just because it has the cover on the side doesn't mean it has the drive gear in the trans. Have the SN# of your trans run by an Allison dealer. Posted 18:49 (#2075071 - in reply to #2074960) Subject: Re: anyone ever put a chelsea pto on a allison automatic? I have a T for a ht754, they are ridiculously expensive. One T on your oil cooler line to lube the pto, and bolt on and shim just like any other. You can get a regular style chelsea pto and dont need the clutched style. Posted 17:46 (#2074960 - in reply to #2074881) Subject: Re: anyone ever put a chelsea pto on a allison automatic? I would think the job could be done in 4 to 5 hours. This is not that hard but a does add a few more parts and time then a pto on a manual tranny. On the automatic they have to add a solenoid and oil lines to lube the pto as well as operated the clutch pack to engage pto. Posted 16:39 (#2074881 - in reply to #2074804) Subject: Re: anyone ever put a chelsea pto on a allison automatic? if you have done it on others it is not a big deal i would not pay that kind of money if you are handy with a wrench We have put them on before and they are basically the same as any transmission pull the side cover put it up there check gear lashing shim as needed and bolt on. Posted 16:06 (#2074846 - in reply to #2074804) Subject: Re: anyone ever put a chelsea pto on a allison automatic? They're telling me on this auto trans installatoin there is way more stuff that has to be done etc. Iv'e installed air shift pto's on manual transmissions before and it was pretty straight forward by following intructions and checking gear backlash etc. Granted things a very busy right now at these sort of shops. They are throwing some interesting labor quotes ranging from $600-$700 to the one place wants over $1000 labor. Its an allison 2500 and it needs a pto put on it. Posted 15:19 (#2074804) Subject: anyone ever put a chelsea pto on a allison automatic? ( logon | register )Īnyone ever put a chelsea pto on a allison automatic? Jump to page : 1 Now viewing page 1
0 Comments
Leave a Reply. |